Vintage 1967-72 CHEV PICK-UP Spécifications télécharger pdf (Page 11)

901150 REV B 4/20/11, INST 67-72 CHEV P-UP wo AC w/ FACTORY AIR CONTROLS EVAP KIT PG 11 OF 24

INNER COWL

DRILL (2)

⁄” HOLES

(2)#14 x ¾”

SHEET METAL

SCREWS

1/4-20 x 1”

HEX BOLT

1/4-20 x 1”

HEX BOLT

FLAT

WASHER

1/4”

FLAT

WASHER

1/4” NUT w/

STAR WASHER

VIEW FROM

PASSENGER SIDE

INSIDE OF CAB

FIGURE 7

FIGURE 7a

EVAPORATOR INSTALLATION

LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD. SECURE LOOSELY TO THE FIREWALL USING

(2) 1/4-20 x 1” HEX BOLTS, (2) FLAT WASHERS AND 1/4” NUT w/ STAR WASHER. SEE FIGURE 7.

NOTE: TO ENSURE PROPER DRAINAGE, IT IS VERY IMPORTANT THAT THE EVAPORATOR IS LEVEL, BOTH LEFT-RIGHT

AND FORE-AFT. CHECK FOR LEVEL ON THE FLAT PORTIONS OF THE CASE AROUND THE DRAIN, BLOCK THE UNIT

UP, THEN DRILL FOR FRONT BRACKET SCREWS.

SECURE THE FRONT EVAPORATOR MOUNTING BRACKET TO COWL USING (2) #14 x 3/4” HEX SHEET

METAL SCREWS SEE FIGURE 7a BELOW.

VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO THE DASH, THEN TIGHTEN ALL MOUNTING

BOLTS. (NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE FRONT MOUNTING BRACKET.)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Vintage 1967-72 CHEV PICK-UP Spécifications Page 11