Vintage 1967-72 CHEV PICK-UP Spécifications télécharger pdf (Page 15)

901149 REV D 7/30/14, INST 67-72 CHEVY PICKUP wo AC EVAP KIT PG 15 OF 24

Glove Box

496067

Final Steps

10.

11.

12.

13.

Install duct hoses as shown in Figure 13, Page 16.

Route A/C wires (12 volt/ground/binary switch/heater valve) through 3/8” grommet as shown in Figure 12,

below.

Install control panel assembly.

Plug the wiring harnesses into the ECU module on the sub case as shown in Figure 13, Page 16 (Wire according

to wiring diagram on Pages 17 and 18).

Install new glove box using OEM screws (See Figure 12a, below).

Install glove box door.

Reinstall all previously removed items, including inner fender.

Fill radiator with at least a 50/50 mixture of approved antifreeze and distilled water. It is the owner's responsibility

to keep the freeze protection at the proper level for the climate in which the vehicle is operated. Failure to follow

antifreeze recommendations will cause heater core to corrode prematurely and possibly burst in A/C mode and/or

freezing weather, voiding your warranty.

Double check all fittings, brackets and belts for tightness.

Vintage Air recommends that all A/C systems be serviced by a certified automotive air conditioning technician.

Evacuate the system for a minimum of 45 minutes prior to charging, and perform a le

ak check prior to servicing.

Charge the system to the capacities stated on Page 4 of this instruction manual.

See Operation of Controls procedures on Page 19.

Figure 12a

Figure 12

Grommet

33144-VUI

Wiring Harness

(12 Volt/Ground/Binary Switch)

Wiring Harness

(Heater Control Valve)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Vintage 1967-72 CHEV PICK-UP Spécifications Page 15